Daily Usage Report for Cove_The Meadows MHC for 03/30/2025

Average Signal Strength: 213

Sometimes transponders will send out data without reading information. This sometimes happens for a few days with newly configured Hexagram transponders. If this condition persists for more than a few days, then they should be rewired or reconfigured.

Total: 1 out of 62 (1.61%)

These meters have a current read of zero. If these meters continue to read zero, the transponder may not be connected to the meter head properly (pulse meters), or the meter is not advancing.

Total: 1 out of 62 (1.61%)

These meters haven't registered any usage in a while, which may mean that either the lot is unoccupied, the residents have moved out temporarily, or the meter chamber is stuck with sand or rust. For Cereniti equipped systems, this could also mean the radio is disconnected from the meter.

Total: 2 out of 62 (3.23%)

The status on the read is marked as not being "OK"; a status is returned for the Master Meter-brand and Metron brand systems only. If a meter is marked as "Leak", it means that water has been running through the meter continuously for at least 24 hours. The "Leak" status is reset 3 hours after a leak is fixed.

Total: 5 out of 62 (8.06%)

A resident is considered an extreme user if their 1-day usage is 1,000 gallons or more. Depending on the circumstances, these residents should be notified immediately.

Total: 1 out of 62 (1.61%)
Total usage: 1,250 out of 5,170 (24.18%)

A resident is considered a high user if their 1-day usage is 250% higher than their per-day 30-day average and their 1-day usage is more than 100 gallons, or their 1-day usage is 300 gallons or more.

Total: 2 out of 62 (3.23%)
Total usage: 950 out of 5,170 (18.38%)

A meter is running backwards when the last read shows a higher reading than the current read.

Total: 1 out of 62 (1.61%)

The ideal voltage for an Aclara Star® MTU is 3.6 volts. Voltages that fall below 3.0 may contribute to intermittent transmissions. If these transmitters are giving intermittent reads, you may want to contact your authorized Aclara reseller.

Total: 6 out of 62 (9.68%)

If a transponder has not transmitted a reading for more than 3 days, then the read shows up here. It is recommeded that you check the transmitter to make sure it is not lying on the ground, broken, missing, or water-logged.

Total: 14 out of 62 (22.58%)

Usage Report

NOTE: The tooltip rendering is done using the truly amazing BoxOver, which can be found at http://boxover.swazz.org/