Daily Usage Report for Lanier MHC for 10/11/2026

Average Signal Strength: 330

These meters haven't registered any usage in a while, which may mean that either the lot is unoccupied, the residents have moved out temporarily, or the meter chamber is stuck with sand or rust. For Cereniti equipped systems, this could also mean the radio is disconnected from the meter.

Total: 3 out of 33 (9.09%)

The status on the read is marked as not being "OK"; a status is returned for the Master Meter-brand and Metron brand systems only. If a meter is marked as "Leak", it means that water has been running through the meter continuously for at least 24 hours. The "Leak" status is reset 3 hours after a leak is fixed.

Total: 9 out of 33 (27.27%)

A resident is considered an extreme user if their 1-day usage is 1,000 gallons or more. Depending on the circumstances, these residents should be notified immediately.

Total: 1 out of 33 (3.03%)
Total usage: 1,840 out of 3,470 (53.03%)

A resident is considered a high user if their 1-day usage is 250% higher than their per-day 30-day average and their 1-day usage is more than 100 gallons, or their 1-day usage is 300 gallons or more.

Total: 3 out of 33 (9.09%)
Total usage: 970 out of 3,470 (27.95%)

The ideal voltage for an Aclara Star® MTU is 3.6 volts. Voltages that fall below 3.0 may contribute to intermittent transmissions. If these transmitters are giving intermittent reads, you may want to contact your authorized Aclara reseller.

Total: 5 out of 33 (15.15%)

If a transponder has not transmitted a reading for more than 3 days, then the read shows up here. It is recommeded that you check the transmitter to make sure it is not lying on the ground, broken, missing, or water-logged.

Total: 12 out of 33 (36.36%)

Usage Report

NOTE: The tooltip rendering is done using the truly amazing BoxOver, which can be found at http://boxover.swazz.org/