Daily Usage Report for ST Hallmark Estates for 01/10/2026

Average Signal Strength: 2,621

Sometimes transponders will send out data without reading information. This sometimes happens for a few days with newly configured Hexagram transponders. If this condition persists for more than a few days, then they should be rewired or reconfigured.

Total: 2 out of 60 (3.33%)

These meters have a current read of zero. If these meters continue to read zero, the transponder may not be connected to the meter head properly (pulse meters), or the meter is not advancing.

Total: 1 out of 60 (1.67%)

These meters haven't registered any usage in a while, which may mean that either the lot is unoccupied, the residents have moved out temporarily, or the meter chamber is stuck with sand or rust. For Cereniti equipped systems, this could also mean the radio is disconnected from the meter.

Total: 3 out of 60 (5.00%)

The status on the read is marked as not being "OK"; a status is returned for the Master Meter-brand and Metron brand systems only. If a meter is marked as "Leak", it means that water has been running through the meter continuously for at least 24 hours. The "Leak" status is reset 3 hours after a leak is fixed.

Total: 2 out of 60 (3.33%)

A resident is considered a high user if their 1-day usage is 250% higher than their per-day 30-day average and their 1-day usage is more than 100 gallons, or their 1-day usage is 300 gallons or more.

Total: 4 out of 60 (6.67%)
Total usage: 1,410 out of 5,649 (24.96%)

If a transponder has not transmitted a reading for more than 3 days, then the read shows up here. It is recommeded that you check the transmitter to make sure it is not lying on the ground, broken, missing, or water-logged.

Total: 10 out of 60 (16.67%)

Usage Report

NOTE: The tooltip rendering is done using the truly amazing BoxOver, which can be found at http://boxover.swazz.org/