Daily Usage Report for ST Spring Oaks for 10/11/2026

Average Signal Strength: 2,401

These meters have a current read of zero. If these meters continue to read zero, the transponder may not be connected to the meter head properly (pulse meters), or the meter is not advancing.

Total: 3 out of 58 (5.17%)

These meters haven't registered any usage in a while, which may mean that either the lot is unoccupied, the residents have moved out temporarily, or the meter chamber is stuck with sand or rust. For Cereniti equipped systems, this could also mean the radio is disconnected from the meter.

Total: 5 out of 58 (8.62%)

A resident is considered an extreme user if their 1-day usage is 1,000 gallons or more. Depending on the circumstances, these residents should be notified immediately.

Total: 1 out of 58 (1.72%)
Total usage: 1,990 out of 6,020 (33.06%)

A resident is considered a high user if their 1-day usage is 250% higher than their per-day 30-day average and their 1-day usage is more than 100 gallons, or their 1-day usage is 300 gallons or more.

Total: 2 out of 58 (3.45%)
Total usage: 440 out of 6,020 (7.31%)

The ideal voltage for an Aclara Star® MTU is 3.6 volts. Voltages that fall below 3.0 may contribute to intermittent transmissions. If these transmitters are giving intermittent reads, you may want to contact your authorized Aclara reseller.

Total: 1 out of 58 (1.72%)

If a transponder has not transmitted a reading for more than 3 days, then the read shows up here. It is recommeded that you check the transmitter to make sure it is not lying on the ground, broken, missing, or water-logged.

Total: 14 out of 58 (24.14%)

Usage Report

NOTE: The tooltip rendering is done using the truly amazing BoxOver, which can be found at http://boxover.swazz.org/