Daily Usage Report for Smittys MHC for 05/28/2026

Average Signal Strength: 976

Sometimes transponders will send out data without reading information. This sometimes happens for a few days with newly configured Hexagram transponders. If this condition persists for more than a few days, then they should be rewired or reconfigured.

Total: 19 out of 149 (12.75%)

These meters have a current read of zero. If these meters continue to read zero, the transponder may not be connected to the meter head properly (pulse meters), or the meter is not advancing.

Total: 1 out of 149 (0.67%)

These meters haven't registered any usage in a while, which may mean that either the lot is unoccupied, the residents have moved out temporarily, or the meter chamber is stuck with sand or rust. For Cereniti equipped systems, this could also mean the radio is disconnected from the meter.

Total: 12 out of 149 (8.05%)

The status on the read is marked as not being "OK"; a status is returned for the Master Meter-brand and Metron brand systems only. If a meter is marked as "Leak", it means that water has been running through the meter continuously for at least 24 hours. The "Leak" status is reset 3 hours after a leak is fixed.

Total: 4 out of 149 (2.68%)

A resident is considered an extreme user if their 1-day usage is 1,000 gallons or more. Depending on the circumstances, these residents should be notified immediately.

Total: 1 out of 149 (0.67%)
Total usage: 6,810 out of 6,829 (99.72%)

A meter is running backwards when the last read shows a higher reading than the current read.

Total: 2 out of 149 (1.34%)

If a transponder has not transmitted a reading for more than 3 days, then the read shows up here. It is recommeded that you check the transmitter to make sure it is not lying on the ground, broken, missing, or water-logged.

Total: 123 out of 149 (82.55%)

Usage Report

NOTE: The tooltip rendering is done using the truly amazing BoxOver, which can be found at http://boxover.swazz.org/