Daily Usage Report for YES! Avon on the Lake for 10/11/2026

Average Signal Strength: 899

These are duplicate transmitter IDs and port numbers.

Total: 4 out of 621 (0.64%)

These meters are reporting water flow into the facility.

Total: 1 out of 621 (0.16%)
Total 1-day pumpage: 74,800
Total 30-day pumpage: 2,992,000

ABT adds comments at the request of the facility; email ABT to add or remove the comments.

Total: 2 out of 621 (0.32%)

Sometimes transponders will send out data without reading information. This sometimes happens for a few days with newly configured Hexagram transponders. If this condition persists for more than a few days, then they should be rewired or reconfigured.

Total: 1 out of 621 (0.16%)

These meters haven't registered any usage in a while, which may mean that either the lot is unoccupied, the residents have moved out temporarily, or the meter chamber is stuck with sand or rust. For Cereniti equipped systems, this could also mean the radio is disconnected from the meter.

Total: 23 out of 621 (3.70%)

The status on the read is marked as not being "OK"; a status is returned for the Master Meter-brand and Metron brand systems only. If a meter is marked as "Leak", it means that water has been running through the meter continuously for at least 24 hours. The "Leak" status is reset 3 hours after a leak is fixed.

Total: 17 out of 621 (2.74%)

A resident is considered an extreme user if their 1-day usage is 1,000 gallons or more. Depending on the circumstances, these residents should be notified immediately.

Total: 1 out of 621 (0.16%)
Total usage: 1,080 out of 39,050 (2.77%)

A resident is considered a high user if their 1-day usage is 250% higher than their per-day 30-day average and their 1-day usage is more than 100 gallons, or their 1-day usage is 300 gallons or more.

Total: 19 out of 621 (3.06%)
Total usage: 5,210 out of 39,050 (13.34%)

A meter is running backwards when the last read shows a higher reading than the current read.

Total: 1 out of 621 (0.16%)

If a transponder has not transmitted a reading for more than 3 days, then the read shows up here. It is recommeded that you check the transmitter to make sure it is not lying on the ground, broken, missing, or water-logged.

Total: 15 out of 621 (2.42%)

Usage Report